Solutions by industry

Water, Pumping & Irrigation — Switchgear & Control Panels in the UAE

For water, pumping and irrigation projects across the UAE, we build LV pump control panels in Dubai for booster sets, transfer and sump pumps, and irrigation lines — with DOL, star-delta or VFD starting, duty/standby alternation, and Multispan water-level controllers for automatic fill, transfer and dry-run protection. Every panel is engineered to IEC 61439 and DEWA practice, using genuine ABB, Schneider and Siemens gear alongside authorized Multispan controllers and protection relays.

Across the UAE, water moves through booster sets on tower rooftops, transfer pumps between ground and roof tanks, sump and drainage pumps in basements, and irrigation lines on landscaped and farm plots — all demanding reliable, protected pump control. High ambient heat, dust and long outdoor cable runs make IP-rated enclosures and proper motor protection essential, while agricultural and remote feeders are prone to single-phasing and voltage swings that destroy unprotected motors. We manufacture pump control panels in Dubai to match each duty: the right starter, level automation, alternation and dry-run cut-out. Genuine ABB, Schneider, Siemens and Legrand components sit alongside authorized Multispan controllers and relays, wired to IEC 61439 and DEWA practice, tested, documented and delivered across all seven emirates and the wider GCC.

What we supply for Water, Pumping & Irrigation

Single and multi-pump control panels with DOL, star-delta and VFD starters, built to IEC 61439 and DEWA practice
Booster set, transfer and sump/drainage pump panels with duty/standby/alternation logic and auto/manual selection
Multispan WLC-22 (single-tank, 3-probe) and WLC-35 (two-tank, 6-probe) water-level controllers for fill/transfer automation and dry-run prevention
Multispan MPD-192 motor-protection relay (to 125 A, 3 CT) and OLR-50100 overload relay for pump motor protection
Multispan SPP-22 single-phasing preventor and VPR-22U voltage relay guarding against phase loss, under/over-voltage and phase-sequence faults
Multispan DT-series/DI-22 timers for star-delta changeover and pump alternation, PS24 SMPS for 24 V controls, plus genuine ABB/Schneider/Siemens contactors, MCCBs and overloads

Typical electrical & control needs

Dry-run protection that stops the pump the moment a tank, sump or well runs empty, before the motor overheats and seizes
Automatic level control across ground and rooftop tanks in high-rise towers, so booster sets fill and cut off without manual switching
Duty/standby alternation on multi-pump booster and transfer sets to balance run hours and keep a spare online
Single-phasing and voltage protection for motors on agricultural, remote and long-cable-run irrigation feeders prone to phase loss and swings
Reduced-inrush starting (star-delta or VFD) on larger transfer pumps to limit voltage dip and water hammer
IP54/65-rated, heat- and dust-resistant enclosures for outdoor pump rooms, rooftop plant and landscape irrigation cabinets

Switchgear manufacturing Multispan instruments Electrical components Request a quote

FAQ

Water, Pumping & Irrigation panels in the UAE

Do you build booster pump control panels for high-rise towers in the UAE?

Yes. We build multi-pump booster panels with duty/standby alternation, automatic level control across roof and ground tanks, and dry-run protection — manufactured in Dubai to IEC 61439 and DEWA practice and delivered across the UAE and GCC.

How does dry-run protection work on your pump panels?

We wire Multispan WLC-22 or WLC-35 water-level controllers together with motor-protection relays so the pump cuts out on low probe level or abnormal current. This stops the motor running dry, which otherwise burns the winding and mechanical seal.

Can you supply irrigation pump panels for landscape and farm sites?

Yes. We build irrigation control panels with timers for zone and cycle sequencing, single-phasing and voltage protection for rural feeders, and IP54/65 enclosures rated for outdoor cabinets in UAE heat and dust.

Which starter should a transfer pump use — DOL or star-delta?

Small pumps run direct-on-line; larger motors (typically above about 7.5 kW) use star-delta or a VFD to cut inrush current and water hammer. We size the starter to your motor rating and confirm it on the single-line diagram with your quote.

Need a Multispan part or a custom panel?

Send us a model number or your requirement — our team responds fast with genuine stock, pricing and lead times across the UAE & GCC.

Request a Quote WhatsApp us